[IRCServices Coding] argh problems problems..

[Colin Thorpe(SCF)]

WE had these problems, this is how we solved it,

for the A kills/Glines, we re-started the services, and addded L and H lines
to the config?? Dunno.. but it fixed it.. so ????!!!
For the op/deop in channels #a and #b - the same settigns etc.. this was a
simple thing of re-stating the services again, and re-registering the
channels, Dropping them, re-starting services, and re-registering,

OperServ's CLEARMODES : - Again, the same solution...

ChanServ's MLOCK doesn't work at all. - and yet again... re-start..

I dont know what IRCD your using, But i bet it's UnrealIRCD,

re-write your config files for the IRCD and hte services, clean it out, take
out un needed lines and check for typos etc, We did all that, and it fixed
our problems...

It also has to do with if you hav multipule servers link4ed, you need U
lines for the server', Server <-> Server U: Lines,

Ghozer


------------------------------------------
irc.linkirc.net
www.linkirc.net
LinkIRC Co-Founder
Clan{SCF} Founder / Leader
Sacrificial ~n~ Cold Fear
www.clanscf.com
#Clan{SCF}
Fear, is not knowing. Terror, is finding out.
----- Original Message -----
From: "prince" <prince at zirc.org>
To: <ircservices-coding at ircservices.za.net>
Sent: Tuesday, October 29, 2002 10:04 PM
Subject: [IRCServices Coding] argh problems problems..


> Alright, I sent an email earlier which caused a lot of arguing about
IRCd's
> but answered none of my questions.
>
> Services do not add G:Lines upon AKILLs being entered, even though the
> option is ENABLED in modules.conf.
>
> OP/DEOP/PROTECT/DEPROTECT only works in certain channels, even though say
> the levels of these commands in channel #a are the same as in channel #b
> they will work in channel #b but not in channel #a.
>
> OperServ's CLEARMODES command doesn't work, stating my U:lines are
> incorrect. (My U:lines haven't changed from ircservices-4.x to 5.x - my
> U:lines are correct unless I was supposed to change them in some way)
>
> ChanServ's CLEAR command doesn't work, for anything.
>
> ChanServ's MLOCK doesn't work at all.
>
> I do not wish to go back to using a 4.x version of ircservices.  Any
> assistence with these problems would be GREATLY appreciated.  Thanks!
>
> -prince
>
> ------------------------------------------------------------------
> To unsubscribe or change your subscription options, visit:
> http://www.ircservices.za.net/mailman/listinfo/ircservices-coding